Male or Female Mounting Stud

Trouble Shooting Permanently Installed AC Accelerometers Powered by a Data Collector
3rd Juli 2020

Male or Female Mounting Stud

Mounting Studs for Accelerometers

Hansford Sensors supply a range of mounting studs, to provide a secure point of connection.

Fig.1

Fig.1 Hansford Sensors top entry accelerometer can be converted from a –01 to a –02 by adding a HS-AS022 mounting stud. For absolute compatibility to a –02, thread locking fluid should also be used.

Fig.2

Fig.2 One problem may arise in that if a replacement senor is ordered using the –01 code then the replacement will not be supplied with a mounting stud.

Fig.3

Fig.3 Shows how flexible a –01 accelerometer can be just by adding all the different mounting threads. Over 28 different mounting studs are available from Hansford Sensors. 22 of these are for the 1/4-28UNF male thread alone.

Fig.4

Fig.4 Shows that side exit accelerometers are only available with male threads.

Fig.5

Fig.5 Shows that a –02 (or –06,-08 or -10) accelerometer can be converted to –01 by removing the mounting stud. This can be accomplished by using a bathroom hair dryer and a pair of pliers (tape over threads to avoid damaging the threads with the pliers).

View our range of mounting studs here.

If you have any further questions, please do not hesitate to get in contact with us.

Es können keine Kommentare abgegeben werden.